Silicone Valve Cover Gaskets 911

0 Review(s) Write a Review

Your Price: $44.16

Questions about this item? Be the first to ask here.

Part Number: SVCG

Availability: In Stock.

Year *

Add Hardware Kit - Zinc-Chromate Locknuts and Aluminum Crush Washers

Quantity

Description

Silicone valve cover gaskets for your 911! Not just a bead, but silicone throughout. Soft enough to conform to irregularities, yet firm enough not to squish out. These can be reused again and again; just rinse them off with soap and water and put them back on. This is a full engine set of 2 upper and 2 lower cover gaskets. Never scrape off stuck gasket material again! Once the surfaces have been cleaned for the initial installation, these gaskets do not leave behind stuck-on material, saving the time and mess of cleaning the surfaces. A light wipe of the aluminum with a mild solvent is all that is required. No solvent should be used on the silicone, just hot water with a little soap, at the most. USA made, ASTM tested, solid silicone with a temperature range of -76 to +450 degrees F. We recommend you replace the locking nuts and aluminum washers each time you remove the valve covers. We have high quality hardware sets available. Recommended Torque: 35-45 Inch Pounds (NOT foot lbs!) 40-53 kg-cm 4-5 Nm

911 Valve Cover Hardware Kit

$20.35

In Stock.

(0)

Add to Wish List

Select Options

Silicone Valve Cover Gaskets 911

Choose Options

Related Items

Mailing List